Your cart is currently empty!
3D glue DimaFix
30.00 лв. (15.34 €)
Dimafix is an innovative adhesive that changes its adhesion properties according to the temperature range typically used for 3D printing.
DimaFix ensures maximum adhesion between the part and the work bed, thus avoiding deformation during printing.
While the bed is hot, the adhesive effect of DimaFix works even with large prints.
When the temperature of the bed or more precisely the “HeatedBed” drops (40-50ºC), the adhesion effect disappears and the part is easily removed.
DimaFix is easy to use, applied in one motion and comfortable for the hand.
Description
Different temperatures lead to different levels of adhesion:
- Below 60 º C: Low adhesion, objects may separate from the mass.
- 60 – 75 ° C: Medium adhesion, for simple geometries.
- 75 – 95 ° C: High adhesion, for complex geometries and long prints.
- Above 95°C: Very high adhesion, for very complex geometries and very long prints.
DESCRIPTION
How to use the DimaFix pen:
- Shake well before use.
- Check that the temperature of the table is below 50°C and apply DimaFix to it.
- Wait a few seconds for the surface to dry and warm up the print bed.
- Keep the bed temperature above 65°C during printing.
- After printing, wait until the table cools down to easily remove the part.
Properties of the DimaFix pen:
- Almost no deformation of the printed part.
- It is suitable for all types of materials (especially ABS).
- Easy removal of the printed part after cooling.
- DimaFix – water-soluble, so the cleaning process is easy.
- DimaFix – the pen can be used over 100 times.
Related products
3D Glue – 3DLac Stick
12.00 лв. (6.14 €)
3DLac – 3DNYLON
40.00 лв. (20.45 €)
3DLAC PLUS
20.00 лв. (10.23 €)
3d Adhesive – 3DLac Spray
20.00 лв. (10.23 €)
